ERIS 855 INOX 3S LED: luz en puerta y laterales

ERIS INOX LED Eco – Seed Germinator

ERIS ECOLine

Seed Germinator and multipurpose climatic chamber for the study of specific climatic conditions in laboratories. Control of internal conditions of temperature, relative humidity, illumination and photoperiod. Own software for total control.

Additional information

Gross capacity (liters)

150, 250, 455, 855, 1345

Configurable parameters

CO2, Humidity Control, LED Lighting, Temperature Control

GENERAL SPECIFICATIONS


 
  • Growth chamber with control of temperature, humidity, LED lighting and photoperiod, for growing plants, seedlings, seeds and in vitro cultures.
  • Horizontal airflow at shelf level, with optional adjustable speed from 0.1 to 0.8 m³/min.
  • TEMPERATURE CONTROL ERIS MODELS Temperature range from +10ºC to +55ºC, with lights on/off.
  • HUMIDITY AND TEMPERATURE CONTROL ERIS HR MODELS Humidity control: Standard working range from 30% to 80% R.H (+/- 3%). With lights off and on.
  • OPTIONAL RANGE EXTENSIONS Temperature: versions down to -10 °C or up to +60 °C. Humidity: extendable to 20 % or 90 % RH and, in limited cases, to 95 % RH.
 

TECHNICAL SPECIFICATIONS


 

  • Temperature control panel and other parameters with 3.4 “TFT graphic display.
  • Ultrasonic humidity generator and horizontal airflow recirculation system.
  • Safety thermostat, avoids exceeding the temperature.
  • Electronic probe to measure humidity (4-20 mA) with precision / stability of +/- 3%.

 

OTHER SPECIFICATIONS


 

  • Homogeneity of +/-1.0 at 27ºC and +/- 1.5 at 40ºC inside the chamber.
  • Stability in the chamber +/-0.3ºC. at 27ºC and +/-0.5ºC, at 40ºC inside the chamber.
  • Humidity stability: +/- 3%, in a temperature range +20ºC to +45ºC.

LIGHTING SPECIFICATIONS


 

  • Standard: neutral white 4000 K LED, up to 220 µmol/m²/s at 150 mm, with full photoperiod. Configurations up to 450 µmol/m²/s at 150 mm, and more on request.
  • 1, 3, 4 or 8 separately dimmable channels, from ultraviolet to far red, 2700 to 7000 K. The 3L LED version combines one deep red and two blue channels.
  • Lights on the door (1S), on both sides (2S), on door and sides (3S) or on each shelf (1L to 4L).

CONTROL


 

  • 4500 series controller, with graphic display of temperature and/or humidity, intuitive and simple user control.
  • 7.0″ TFT backlit graphic display.
  • Acoustic and visual alarm.
  • 3 levels of numerical password protection (user, supervisor, technical service), with reprogrammable PIN codes.
  • Back-up battery, with automatic recharge, guaranteeing autonomy for 48 or 72 hours.
  • Data logging every 15 minutes with USB download and Ethernet MODBUS TCP/IP connection. Optional EQUITEC FITOCONTROL software to control and monitor the chambers from a PC or phone.

CONSTRUCTION


 

  EXTERIOR   Epoxy coated steel. 4 height adjustable feet.
  INTERIOR   AISI304 stainless. Rounded corners and interior drainage.
  DOOR   Blind door with handle and key lock. 6mm thermal glass internal door.
  POWER   220-240V /1 F/ 50 Hz. 1.5 m cable with Schuko connector.
  SHELVES   In stainless steel. perforated + height-adjustable guides. Max load 100 kg/m2.
  COOLING   Forced air ventilation. Cold control controlled by solenoid valve.

OPTIONAL ACCESORIES


 

  • Extended-range versions: down to -10 °C or up to +60 °C.
  • Extended drying capacity up to +10% RH, with additional air dryer.
  • Light radiation sensor, for control and recording of light parameters.
  • Additional trays.
  • Telescopic trays, with extraction system.
  • Additional pass ports for cables and tubes20 liter external water tank with electric pump and safety valve for the humidifier feed water.
  • Continuous demineralization system for the humidifier feed water.
  • Internal sockets.
  • Potential-free output for remote alarm control (4-20 mA).
  • GSM alarm module.
  • RS485/232 remote communication system.
  • Communication software for PC on request.
  • UV light tube for sterilization.
  • CO2 control and supervision units.
  • Water cooled condensing unit.Digital printer for temperature and/or humidity.
  • Ethernet output for remote connection via WiFi network and dedicated website, makes it possible to read and change parameters.
  • Bio-decontamination with hydrogen peroxide: allows the connection of an H2 O2 atomizer system.
  • Thermal decontamination system at 60°C.
  • 7-day circular temperature/humidity recorder, with independent battery to work even in case of power failure. Includes 100 charts (approx. for 1.5 years).).
  • Additional Data loggers.
  • PAR radiation sensor, PPFD and spectrum meters, air renewal, CO2 control, shakers and irrigation.

UNDERSTANDING THE NAME OF THE MODEL



ERIS INOX LED

E – Equitec    R – Refrigerated / Refrigerado.     I – Incubator / Incubador     S – Screen / con Pantalla

INOX – Stainless Steel / Inoxidable.     LED – LED Lights / Luces LED

LinkedIn
WhatsApp
Twitter
INQUIRIES FORM

REQUEST INFORMATION

Send us your inquiry about this product.

ERIS INOX LED Eco – Seed Germinator

ERIS 855 INOX 3S LED: luz en puerta y laterales

Data protection. Controller: Testing Lab Equipments, S.L. Purpose: to answer your enquiry or request. Legal basis: pre-contractual steps taken at your request. Recipients: authorised TestingLab distributors when needed to serve you; we do not disclose your data for any other purpose. Rights: access, rectification, erasure and others, at contact@testinglab.es. More information in our Privacy policy.